Secondary Hull…ASSEMBLEEEEEEEE!!
I feel like I should post more but honestly I covered pretty much everything I wanted to say in this video. So check it out! Next time you see this secondary fuselage it should be all painting and getting ready to join the saucer section!
One week to go…
Glad to see you finally plucked up the courage to get started on this beast Doug!
I too was a bit concerned about the aluminum tape shorting things out (well, I will be when I evenually get round to tackling my big E), and have been experimenting with a second layer of tape (insulating this time) on top of the aluminum tape in the areas at risk – might be worth a try?
Going to be building the new PL TOS Enterprise? : )
Nice work so far btw.
Bernie
Hey Bernie! Thanks for the comment!
Ya the foil tape is pretty tricky. It reflects light amazingly and insulates your wires really well but if things get packed tightly, you’ll definitely start see some shorts like I was finding in my saucer. A trick I used was just using the wax paper from the backside of foil tape to kind of “sandwich” the problem areas. It’s a pretty simple trick but it took quite a few times tearing off the misbehaving foil tape to figure that one out, haha.
And ya I can’t wait for the 1/350 TOS Enterprise to get out into the wild. Did you sign up for the 1701 club too? It really looks amazing, especially because of the included lights and motors. No more headaches from Arduino coding! haha. Thanks again for all your help on that too btw!